Force10 Networks PSeries 100-00055-01 Manual do Utilizador descarregar pdf (Página 26)

26 Graphical User Interface

GUI Commands

From the Runtime Statistics display, you can enter commands to control the DPI (see Table 3, or enter the

h command from the GUI command line).

Figure 13

fn9000010

N/A/1 FlowTimeout=16 Packets/flow=0 Truncation=0 Irq period=5ms

CPU(s): 0.0% user, 0.0% nice, 0.0% system, 0.0% interrupt, 100% idle

Runtime Statistics - FPGA Unloaded

Note: GUI commands that require a subsequent value entry have the current value displayed in

parentheses at the prompt.

Table 3 GUI Commands

Command Description

a Establishes the IRQ period (measured in milliseconds), which moderates DPI access to the PCI-X

bus. Valid values are 1 to 255, where 1 is no throttling, and 255 is maximum throttling.

c This command is not supported.

d Brings the OS network interface down and disables matching.

f Establishes the maximum number of packets to be captured for each flow (Packets/Flow). A value of

0 specifies all packets.

h Displays help information about the commands.

i Establishes the display refresh interval (measured in seconds).

m Invokes a dialog menu through which dynamic rules can be defined, capture/forwarding policies can

be set for each individual rule, and the firmware can be selected and loaded.(see Figure 14).

q Exits the graphical user interface.

r Reset all the OS counters.

s Starts or restarts the drivers and reloads the firmware.

t Establishes the number of seconds after which a flow is considered expired (Flow Timeout).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 131 132

Sem comentários

Force10 Networks PSeries 100-00055-01 Manual do Utilizador Página 26